全自動硅料清洗設備機具有清洗效果好，操作簡單等優點，廣泛應用于表面噴涂處理行業、機械行業、電子行業等。在其使用過程中，注意事項有如下幾點：

Full automatic silicon material cleaning equipment has the advantages of good cleaning effect and simple operation. It is widely used in surface spraying treatment industry, machinery industry, electronic industry, etc. During its use, the following points should be noted:

1、超聲波清洗機電源及加熱器電源須有良好接地裝置。

1. The power supply of ultrasonic cleaning machine and heater must be well grounded.

2、超聲波清洗機嚴禁無清洗液開機，即清洗缸沒有加一定數量的清洗液，不得開超聲波開關。

2. It is strictly forbidden to start the ultrasonic cleaning machine without cleaning fluid, that is, the ultrasonic switch cannot be turned on without adding a certain amount of cleaning fluid to the cleaning cylinder.

3、有加熱設備的清洗設備嚴禁無液時打開加熱開關。

3. It is forbidden to turn on the heating switch when there is no liquid in the cleaning equipment with heating equipment.

4、禁止用重物（鐵件）撞擊清洗缸缸底，以免能量轉換器晶片受損。

4. It is forbidden to strike the bottom of the cleaning cylinder with heavy objects (iron pieces) to avoid damage to the chip of the energy converter.

5、超聲波發生器電源應單獨使用一路220V/50Hz電源并配裝2000W以上穩壓器。

5. The power supply of ultrasonic generator should use a 220v/50hz power supply separately and be equipped with a voltage stabilizer of more than 2000W.

6、清洗缸缸底要定期沖洗，不得有過多的雜物或污垢。

6. The bottom of the cleaning cylinder should be washed regularly without too much debris or dirt.

7、超聲波清洗設備廠家建議您每次換新液時，待超聲波起動后，方可洗件。

7. The manufacturer of ultrasonic cleaning equipment recommends that you wash the parts after the ultrasonic starts every time you change the liquid.

通過以上對全自動硅料清洗設備機使用注意事項相關的介紹，相信您對自動化設備有了一定的了解。如果有這方面的問題請點擊鏈接提交需求，我們m.400qy.cn會幫您解決問題。

Through the above introduction to the precautions for the use of automatic silicon material cleaning equipment, I believe you have a certain understanding of automatic equipment. If you have any problems in this regard, please click the link to submit the requirements, and we m.400qy.cn will help you solve the problem.